11/12/2023 0 Comments Landscape lighting connectors![]() These sealants are neutral rather than acidic and so won’t be corrosive. So yes, they will waterproof your wire nut, but they’ll also corrode the wires.Īlkoxy sealants instead have a by-product of either methanol or a mix of methanol and ethanol. Since they’re acidic, they are corrosive too. They release acetic acid as they cure, which gives these sealants that vinegar-like smell when you use them. However – and this is crucial – there are two main types of silicone sealant, and you have to make sure you get the right one.Īcetoxy sealants are most commonly used for sealing showers or kitchen areas. You can do this using an RTV silicone sealant that you can find in most hardware stores. To use them outdoors, you’ll need to waterproof them first. You simply insert the stripped wire ends and twist the nut, and it binds them together using a cone-shaped spring to prevent them from coming loose except under severe force. Wire nuts are some of the simplest ways of connecting wires. However, if you don’t want to solder the connections, then you’ll want to look at easier options. Options could include heat-shrink adhesive tubing, or self-fusing silicone tape (Amazon). There are many options available, but if you’re soldering the wire yourself, you’re going to need to make sure the entire connection is coated with something that will stop water from getting in. So, to protect the safety and durability of your landscape lighting setup and just make sure it keeps working as it should, you need to waterproof those connections. Their strength becomes an issue if you have a weak point because the moisture has nowhere to drain (apart from the same weak point, which may never happen depending on how the cable is laid). That’s because the wires are so well waterproofed and insulated. Once moisture gets into the cable through a connection, it has a hard time escaping again. It’s even more of a problem with landscape lighting. Then there’s also the issue of corrosion – moisture could rust and damage the wire over time. You could see a current surge which could also impact your lights or whatever else you’ve added to the landscape lighting circuit. ![]() In case it happens at a connection point. This can, in turn, damage the wire and make it less safe in general. If a cable gets wet, then you’re creating the opportunity for electricity to arc between droplets.Ī circuit is designed for a regular flow of current along the wire, so any ‘extra connections’ between water droplets could cause overheating with the increased current flow.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |